Radiant tube type black wave infra ‘amp; CALOR Schwank

Machines generate heat, fueled by natural gas, methane or propane.
Heating equipment is independent, unique individual combustion fan.
Combustion takes place in the combustion chamber is made of tubular corrosion and heat transfer by radiation is performed using special reflectors mounted above the pipe.
Block command and control function and control both supravegheza this flame blocking device if it senses a malfunction.
With Tube Heaters can heat large areas with poor insulation, or just certain areas.
Where you do not want large amounts of air circulation due to dust can be successfully used these tubes.
The heat required is achieved without generating air flows without walls or ceiling energieprin spread.
Because air does not heat, is thermal inertia small.
Radiant heat transfer with maximum heat produced without intermediate heat exchange losses.
The main components of the radiant tube are: outer burner, radiant tube or a U-shaped, fan flue, reflectors and mounting brackets. The main components of the radiant tube are: outer burner, radiant tube or a U-shaped, fan flue, reflectors and mounting brackets.
Combustion is controlled by an electronic device placed inside the box burner ignition command, open the gas supply, flame control and off automatically in case of gas supply failure. The combustion chamber is a U-shaped tube with trapezoidal profiles on the inside for better heat distribution along the tube, thereby obtaining a uniform radiation.
The draft fan located at the other end of the tube provides gazelorde combustion exhaust out. For the evacuation of combustion gases are given several options. Exhaust system type B1: combustion air is taken in the cavity and the combustion products are then released directly onto the outside with a 80 or 100mm diameter pipe.
Exhaust System Type C: combustion air taken from outside the area, and combustion products are directed through a common pipe inlet / outlet of each radiant tube in hand, through the wall or ceiling.
Exhaust Type D: combustion products is done centrally for up to 10 tubes radiating circuit with a special fan.
Radiant tubes can be mounted on the ceiling or wall straight or angled up 30 °, and radiates an angle of 120 grade. Low mounting height is 12m maximum 3.5 miar.
They are used mainly in deposits.

A good evening!