Primo Ceramic Radiant & over Schwank

Heating of industrial halls or ceramic radiant tube heaters

Heating appliances are gas or propan.Transmiterea radiatie.Functioneaza the heat by infrared radiation is visible and red invizibila.Radiantul mixed gas is composed of:

The device of the ceramic surface is visible radiation and mixing chamber triangular area of ​​radiation which is invisible. Ignition and control unit (Honeywell type) which is composed of an electronic box transistorised block Solenoid regulator with a step or two steps of power (60% and 100%), spark ignition and flame control by ionization probe .

Radiant infrared gas are equipped with reflectors to guide the radiation produced in the direction of the reflector allows special dorita.Constructia transformation heat loss in radiant heat, infrared heat that is gained additional fill light radiation efficiency.

Full isolation of radiant infrared radiant application of an outbreak can lead to fuel savings of 20% heat loss that occurs during the combustion process is effectively exploited by over Schwank. At one minute after the system has been coupled, infrared radiant gas reaches full capacity and radiant heat can be felt immediately.

During operation, the radiant is monitored by a control unit and the flame ionization gas in case of withdrawal or blood, an electromagnetic valve automatically closes the gas supply. Because the combustion process is quick NOx emissions are reduced (approximately 10ppm) making these heaters be green.

Radiant ceramic structural assembly depends on the situation of space systems and the way the building is utilizata.Radiant can be mounted vertically, slanted ceiling or wall. Using Infrared Radiant Gas can heat large spaces with poor thermal insulation, even open spaces such as stadiums, winter, or only certain areas.

Where circulation is not desired because aerdin large volumes of dust, can successfully use these radiante.Caldura required is achieved without generating air currents without energy dispersion through the walls and ceiling.

Because air does not heat, thermal inertia is mica.Caldura by transmitting the radiation is used for maximum heat produced without intermediate heat exchange losses.

Evacuation of combustion gases can be directly or indirectly with the intake manifold gas mixed with ambient air that is discharged over Radiant using fans mounted on the wall or roof. Low mounting height is 4m thus ensuring a minimum distance from any flammable materialsand and maximum 40m,

It is forbidden to mount a distance of 2m from flammable materials.

.